Compact HPL Partitions in El Katameya, Cairo
El Katameya sits where the Ring Road, the Third Settlement and the desert developments meet, which gives it an unusual mix of buildings. Katameya Heights and Katameya Dunes run golf and country club facilities, Downtown Katameya carries retail and food and beverage, and the light industrial and logistics units along the Air Defence Road operate staff washrooms on shift patterns. Cairo House EG supplies and installs compact HPL partitions across all of them.
What compact HPL partitions are, and why Katameya facilities need them
Compact HPL is high pressure laminate manufactured as a solid board rather than a decorative face over a soft substrate. Kraft paper is saturated in phenolic resin and pressed under heat into one dense homogeneous slab, normally 12mm or 13mm for cubicle work. The board carries its own load and is waterproof through its entire thickness.
Katameya combines two demanding environments in a small area. Golf and country club changing facilities deal with wet floors and constant humidity, which is the classic failure condition for anything with a board core. At the other end, the logistics and light industrial units along the Air Defence Road run staff washrooms in dusty conditions with high frequency use across shifts.
Both need the same answer for different reasons. A non porous panel that wipes clean handles the dust, and a waterproof core handles the wet. The common factor is that the panel itself never becomes the maintenance item. Hinges and latches wear, and stainless steel 304 fittings unbolt and swap without disturbing the panel or closing the room.
Panel and hardware specification
| Specification | What we supply for Katameya washrooms |
|---|---|
| Panel thickness | 12mm standard cubicles, 13mm for high traffic and public washrooms |
| Core | Solid phenolic kraft core, waterproof through the full thickness |
| Hardware | Stainless steel 304 hinges, indicator locks, brackets, pilaster shoes, coat hooks |
| Door action | Gravity or spring hinges, self closing, adjustable to open or closed rest |
| Head rail | Anodised aluminium, continuous over the cubicle run |
| Floor fixing | Adjustable stainless feet, levels out uneven screed |
| Typical lead time in El Katameya | Five to eight working days after approval |
| Finishes we move most here | Sand neutrals and woodgrains for club interiors, hard solids for industrial |
Where compact HPL earns its cost in El Katameya
Golf and country clubs
Katameya Heights and Katameya Dunes run changing rooms and pool facilities where standing water is a daily condition rather than an occasional event.
Retail and dining
Downtown Katameya carries public washrooms with weekend peaks well above weekday traffic, concentrating wear into short bursts.
Logistics and light industrial
The units along the Air Defence Road run staff washrooms across shifts in dusty conditions, where a wipe clean non porous surface is the only practical choice.
Compound clubhouses
Residential compounds through the Third Settlement operate gyms and clubhouses that need commercial grade cubicles and lockers.
Clinics
Medical practices serving the Katameya and Third Settlement population need seamless surfaces without grout joints for a hygiene review.
Schools
Schools across the Third Settlement move large groups through washrooms in short breaks, putting the whole load on door edges.
What we supply and install in El Katameya
Cairo House EG has supplied construction finishing materials in Cairo since 2015 and holds the exclusive Egypt agency for UNISCE compact HPL panels. Everything below is fabricated and fitted by our own teams rather than subcontracted out.
Washroom cubicle systems
Cubicle systems built from solid grade board, so the door edge is the same material as the face and cannot delaminate. See our core HPL partition line.
Latch hardware
Latch sets that survive constant use and can be swapped out individually rather than as a whole door. See partition lock range.
Support brackets
Stainless brackets that carry the panel load into the wall properly, which is where cheap installations usually fail. See partition support brackets.
Adjustable pilaster feet
Pilaster shoes that cover the fixing and keep water away from the base of the panel. See adjustable pilaster feet.
Hooks and door bumpers
Coat hooks fixed through the panel properly rather than surface stuck, so they survive being leaned on. See door bumper fittings.
Raised access flooring
Access floor panels and pedestals installed to the finished floor level agreed at survey. See raised flooring installation.
Serving El Katameya and the eastern developments
We work from El Nozha El Gedida in Heliopolis, and Katameya is a straightforward run via the Ring Road or the Suez road depending on the hour. Close enough for a same week survey, and close enough for a fitter to come back for an adjustment without a chargeable visit.
On the same corridor we cover New Cairo, the Fifth Settlement, Rehab, Madinaty, Shorouk and Mostakbal City. A single crew working the eastern side can reach several sites in a week.
Club and compound access is the usual constraint here rather than distance. Gate passes, delivery windows and restrictions on working during club hours all get recorded at survey so the programme holds. You can also see our company site.
What to expect when you work with us
Most washroom packages fail at measurement, not installation. Our process removes that risk before a single panel is cut.
- Site survey. We measure the built washroom in El Katameya rather than working from the drawing, because wall plumb, floor level and drainage falls on site rarely match what was issued.
- Layout and panel selection. You receive a cubicle layout with door swings and clear widths marked, plus physical panel samples so the colour is approved under your own lighting instead of on a screen.
- Quotation. Itemised by panel, hardware and installation, so you can see what is being priced and adjust the specification if the budget needs it.
- Fabrication. Panels are cut, edge finished and drilled to the approved layout. Sheets stay under factory film until they reach site.
- Installation. Our fitters set out, install head rails, pilasters and doors, then adjust every hinge and latch before handover. Club work is scheduled outside member hours where the facility requires it.
- Handover and after sales. We walk the finished washroom with you, hand over spare hardware, and stay reachable for adjustments once the space is in real use.
Find Us on Google Maps
Frequently Asked Questions
Our golf club changing rooms are wet constantly. What actually survives that? A waterproof panel and stainless steel 304 hardware. Compact HPL has no core to absorb water, and 304 fittings do not corrode at the fixing points, which is where plated steel fails first in a wet changing room.
Can you supply matching lockers and benches for the changing rooms? Yes, fabricated from the same compact HPL panel with matching stainless fittings, so the whole changing room carries one specification and one spares list.
Our staff washrooms are dusty from the yard. Is that a problem for the finish? No. The surface is non porous and wipes clean with standard commercial cleaners. There is no coating or sealant on top that dust and cleaning would gradually strip away.
Can you work outside club opening hours? Yes. Club and compound work is normally scheduled outside member hours. We agree the window at survey stage and plan delivery, cutting and installation around it.
What thickness suits a club or retail washroom in Katameya? 13mm for public club and retail washrooms. 12mm is sufficient for staff washrooms and low traffic clinic rooms and costs less.
Do you handle gate access and delivery windows for gated developments? Yes. We collect the requirements at survey and submit vehicle and crew details in advance rather than arriving with a loaded truck and no pass.
How fast can you survey a Katameya site? Normally within the same week. We are close enough that a survey does not need to be planned far in advance.
What does a compact HPL partition cost in El Katameya? It depends on thickness, colour, cubicle count and hardware. Send the layout or rough dimensions and we return an itemised quotation.
Get a quote for your El Katameya project
Send the washroom layout or the cubicle count and rough dimensions and we will return an itemised quotation. If changing room lockers are part of the scope we will price those together.
Site visits across Katameya and the Third Settlement are arranged within the same week. To request a site visit, call or message us any time.
Phone: +201066672094 or +201223111265
Website: cairohouseeg.com
Hours: Open 24 hours, 7 days a week
Address: 3 Misr Lel Tayaran Street, Block 1314, Civil Aviation Buildings, next to Sindbad, El Nozha El Gedida, Cairo 11843