Compact HPL Partitions in Shubra, Cairo
Shubra Street runs commercial ground floor almost end to end, which gives the district one of the highest concentrations of small business washrooms in Cairo. Dawaran Shubra keeps traffic moving, the Rod El Farag Axis brought new access, the markets trade all day and the churches along the street draw congregations at the weekend. Cairo House EG supplies and installs compact HPL partitions across the district.
What compact HPL partitions are, and why Shubra businesses need them
Compact HPL is high pressure laminate produced as a solid slab rather than a thin face over a soft core. Kraft paper is saturated in phenolic resin and pressed under heat into one dense board, normally 12mm or 13mm for cubicle work. Cut it anywhere and the edge matches the face, which is why it does not delaminate or swell.
Shubra washrooms are small, internal and heavily used, which is the worst combination for cheap partition systems. A unit on Shubra Street might have a two cubicle washroom serving staff and a steady stream of customers from morning until late, in a room with no window and a single extract fan that may or may not work.
That environment kills laminated board on a timber core within two or three years, and the failure is always the same: water at the bottom edge, a swollen core, a lifted face and a door that will not close. Solid panel construction removes the mechanism entirely, which is why a Shubra washroom fitted properly once should not need touching again for well over a decade.
Panel and hardware specification
| Specification | What we supply for Shubra washrooms |
|---|---|
| Panel thickness | 12mm standard cubicles, 13mm for high traffic and public washrooms |
| Core | Solid phenolic kraft core, waterproof through the full thickness |
| Hardware | Stainless steel 304 hinges, indicator locks, brackets, pilaster shoes, coat hooks |
| Door action | Gravity or spring hinges, self closing, adjustable to open or closed rest |
| Head rail | Anodised aluminium, continuous over the cubicle run |
| Floor fixing | Adjustable stainless feet, levels out uneven screed |
| Typical lead time in Shubra | Four to seven working days after approval |
| Finishes we move most here | Mid greys and dark solids that hide daily marking |
Where compact HPL earns its cost in Shubra
Retail and shops
Ground floor retail along Shubra Street runs washrooms shared between staff and customers from morning until late with no quiet period.
Restaurants and cafes
Local restaurants operate very small washrooms with concentrated evening turnover and no spare width for an inaccurate cut.
Markets and trade
The market areas trade all day, putting far more use through a small washroom than its floor area would suggest.
Clinics
Neighbourhood clinics and pharmacies need seamless non porous surfaces that keep clean without relying on tiled walls and grout lines.
Churches and community buildings
The churches along Shubra Street handle congregation surges at weekends, with washroom and ablution facilities in heavy short term use.
Workshops and small offices
Light workshops and small offices across the district run compact staff washrooms that standardise easily onto one detail.
What we supply and install in Shubra
Cairo House EG has supplied construction finishing materials in Cairo since 2015 and holds the exclusive Egypt agency for UNISCE compact HPL panels. Everything below is fabricated and fitted by our own teams rather than subcontracted out.
Toilet partition runs
Toilet partitions fabricated to the surveyed dimensions, not to the drawing, which is what keeps door gaps even on site. See HPL compact cubicles.
Wall cladding
Full height panel cladding for wet walls and corridors, a practical alternative to tile and grout. See HPL wall cladding.
Indicator locks
Indicator latches that read clearly from a distance, which matters in high traffic public washrooms. See cubicle door locks.
Hooks and door bumpers
Coat hooks fixed through the panel properly rather than surface stuck, so they survive being leaned on. See door bumper fittings.
Corian washroom counters
Vanity counters that pair with compact HPL cubicles and hold up to the same cleaning regime. See integrated basin vanity units.
Corian table tops
Custom table tops for restaurants and cafes, cut to shape and fitted to your chosen bases. See fabricated Corian tables.
Serving Shubra and the northern districts
We work from El Nozha El Gedida in Heliopolis and reach Shubra through the Rod El Farag Axis or the Ahmed Helmy route depending on the hour. Close enough for a same week survey and for a fitter to return for a small adjustment without a chargeable trip.
From the same base we cover Shoubra El Kheima, Rod El Farag, Ain Shams, Abbassia and Downtown. Landlords with several units across the north usually give us the whole set rather than splitting them.
Access is the real constraint here. Shubra Street loading is difficult at almost any hour, many buildings have no lift and stairwells are narrow. We record the route at survey and cut panels to suit so the delivery actually gets into the building. You can also see other districts we cover.
What to expect when you work with us
Most washroom packages fail at measurement, not installation. Our process removes that risk before a single panel is cut.
- Site survey. We measure the built washroom in Shubra rather than working from the drawing, because wall plumb, floor level and drainage falls on site rarely match what was issued.
- Layout and panel selection. You receive a cubicle layout with door swings and clear widths marked, plus physical panel samples so the colour is approved under your own lighting instead of on a screen.
- Quotation. Itemised by panel, hardware and installation, so you can see what is being priced and adjust the specification if the budget needs it.
- Fabrication. Panels are cut, edge finished and drilled to the approved layout. Sheets stay under factory film until they reach site.
- Installation. Our fitters strip the old system where needed, set out, install head rails, pilasters and doors, then adjust every hinge and latch before handover. Most small washrooms are completed in a single day.
- Handover and after sales. We walk the finished washroom with you, hand over spare hardware, and stay reachable for adjustments once the space is in real use.
Find Us on Google Maps
Frequently Asked Questions
Our washroom has only two cubicles. Is that too small a job? No. Small washrooms are a large part of what we do, and the same survey and fabrication accuracy applies. A two cubicle replacement is typically fabricated in under a week and fitted in one day.
The old doors swelled and will not close. Can you replace just those? We would normally replace the run rather than individual doors, because if one has failed the rest are usually at the same stage. Where the floor and walls are sound the replacement fits the existing layout.
Our washroom has no window and stays damp. Is that a problem? No. Poor ventilation destroys partitions with an absorbent core. Compact HPL has no core, so persistent humidity has nothing to soak into and nothing to lift.
Loading on Shubra Street is very difficult. How do you deliver? We cut panels to size in the workshop and plan the vehicle and timing around the street at survey stage, rather than arriving with full sheets at the busiest hour.
Can you work outside shop opening hours? Yes. Most Shubra work happens outside trading hours, agreed at survey so delivery, cutting and installation are all planned around your business.
What thickness should a small shop washroom use? 12mm is normally sufficient and costs less. Use 13mm where the washroom serves a genuinely public flow all day, such as a market or a busy food outlet.
Is the hardware included in the price? Yes. Hinges, indicator locks, brackets, pilaster shoes and coat hooks in stainless steel 304, supplied as one matched set with spares handed over so you can replace a fitting yourself.
What does a compact HPL partition cost in Shubra? It depends on cubicle count, panel thickness, colour and hardware. Send rough dimensions or a photo of the room and we return an itemised quotation.
Get a quote for your Shubra project
Send the cubicle count and rough dimensions, or simply a photo of the washroom, and we will return an itemised quotation including strip out where it is needed.
Survey visits across Shubra and Rod El Farag are usually arranged within the same week. To start the conversation, call or message us any time.
Phone: +201066672094 or +201223111265
Website: cairohouseeg.com
Hours: Open 24 hours, 7 days a week
Address: 3 Misr Lel Tayaran Street, Block 1314, Civil Aviation Buildings, next to Sindbad, El Nozha El Gedida, Cairo 11843